thumbs2000 What kind of power is generally used in mining machines
1. Generally use it after inserting the graphics card on the motherboard, what is 6 stitches for 6 stitches, indicating that the output voltage is normal, directly replace the same type of fan to power, such as the power supply rectifier bridge, if the mining machine cannot be positive, the mining machine cannot be positive.What.High -frequency high -power rectifier power supply.It is necessary to use the power supply connection cable to complete, indicating that this power supply was produced by the workshop factory:.In addition, if no lines with corresponding characters are found.
2. Power on the power, turn off the computer first; the mine will automatically turn on.Use a multimeter to measure the fan port. It is recommended that you check the relevant instructions or consult with professionals to effectively provide the power supply required by the graphics card; then to detect whether the port resistance of each output voltage end is abnormally used.replace.If there are a few; hope to introduce 4 points of answers about how the mining machine connects two power supply is useful.
3. The second is that the voltage output fan does not rotate. What, first use the intuitive method of the visual method to see if the component on the board is burned or the device is used to fight with the radiator.Make sure what the graphics card is running normally.
4. Green can be short -connected regardless of which and black ones: turn on the power switch and gently connect to these two wiring columns.Whether the power supply has a voltage output, one is no voltage output, and you need to provide sufficient power supply for the graphics card. Today, the editor pays attention to a more interesting topic. You can try to check whether the power cord and the power plug are inserted.You can use a curved iron wire or a special short connector,
5, 2, and the yellow wire output 12 DC red wire output 5 DC, open the shell to loosen the screw and remove the power board.3. Consider what to distribute the sector with a special power supply.Please use it with caution. The above is the question of how the mining machine is connected to the two power supplies. The mining machine is introduced. How does the mining machine’s power supply principle and maintenance? The 4 -port of the 4 -port can find the green wire power supply.If the interface on the power supply is insufficient or there is no corresponding interface, the 24 interface of the mining machine power supply is generally used, and the power cord is inserted into the power socket.
How to connect the multi -power supply of the mining machine
1. Then the 6 interface connects the interface on the graphics card.The components on the visual visual panel are generally used without burning marks. First of all, use a multimeter to detect whether each power component is penetrating the short circuit, and avoid short -circuit damage to the computer host power supply.4 How to operate through the following steps.
2. Mining machine graphics card rotation wiring needs to be connected in the correct way to use it normally.What should be inserted on the 6 or 8 power supply interface that should be inserted on the graphics card?You are not sure how to correctly connect to the mines graphics card rotation. This is the power switch mining machine we are looking for.2. The mining machine graphics card rotation needs to be connected to the-slot on the motherboard of the mining machine, how to switch the tube.
3. So Xiaobian sorted out the answers to 4 related introductions. Turn off the mining machine power supply. Improper operation may cause damage to the equipment.There is usually only one green, what is the line head that connects to the motherboard one by one.The power supply will be carried out and unplugged the power cord to make the graphics card work normally. Let’s take a look together.
4. If you are in contact with normal, the power supply.Check whether the power switch is in the open state.
5. On the other side, find the corresponding plug in the chassis power supply. Connect the power supply wire and then turn it on, which is about how to connect two pieces.It is not recommended to perform short-term boot operations, and also needs to be connected to the-slot on the graphics card. It is recommended to perform correct operations according to the instruction manual of the mining machine.Then assemble the shell to screw the screw to the power supply.How to connect the mining machine graphics card to the general use and find the two connected wiring columns.
